Error Code Canon MP160 and MP145 and reset the printer

Browse » home» canon » Error Code Canon MP160 and MP145 and reset the printer

1. Turn off the printer (power
cord is still plugged in), press and hold

the STOP
/ RESET and then press the ON / OFF and release the

STOP / RESET

2. Hold ON / OFF button, than press the STOP
/ RESET 2x

3. Release both buttons
and the printer will enter SERVICE MODE

(appears the number ZERO)

4. The printer charging

5. After the printer has
finished charging, press the STOP / RESET 4x.

6. Each time the STOP /
RESET button, the lights ON / OFF will turn

green
and orange.

7. Press the ON / OFF 1X,
the number changed to ONE (1)

8. Turn off the printer
and unplug the POWER Cable.

9. Turn the printer back On

E2-2 = No paper (ASF)

E3-3 = Paper hours

E4 = No ink

E5-5 = The ink cartridges
are not installed or a non-supported ink

cartridge is installed, or the ink cartridges
are not installed

properly

E8 = Waste ink absorber full, or platen waste
ink absorber full

E9 = The connected digital camera / video
camera does not support

Camera Direct Printing

E14 = The Ink Cartridges Whose destination are
wrong

E15 = Ink cartridge is not installed E16 - Ink
remaining is unknown

E16-E19 = Failed to scan
head alignment sheet

E22 = Carriage error

E23 = Paper feed error

E24 = Purge unit error

E25 = ASF (cam) sensor
error

E26 = Internal temperature
rise error

E27 = Waste ink absorber
full or platen waste ink absorber full

E28 = Ink cartridge
temperature rise error -

E29 = EEPROM error

E33 = Paper feed position
error

E35 15 = USB Host VBUD
Overcurrent error - USB

E37 17 = Abnormal motor
driver error

E40 20 = Other hardware
error

E42 22 = Scanner error

Advertisement

Printer Manual reset